How To Make A Flying Bee From A Magnet

Table of contents:

How To Make A Flying Bee From A Magnet
How To Make A Flying Bee From A Magnet

Video: How To Make A Flying Bee From A Magnet

Video: How To Make A Flying Bee From A Magnet
Video: How to Make Levitating Pencil 2024, December
Anonim

Fold up the two magnets and see how they behave. If magnets are stacked with the same poles, they will repel each other. With the help of two magnets, you can make a bee flying over a flower. The bee magnet will bounce off the lower flower magnet, causing the bee to fussily swing over the flower.

bee over flower
bee over flower

Necessary

  • - shoe box
  • - thick colored paper
  • - two round magnets
  • - yoke with thread
  • - scissors
  • - Double-sided tape
  • - glue stick
  • - colored tissue paper
  • - Scotch
  • - pipe brushes

Instructions

Step 1

Cover the inside of one short side of the box with green paper and all other sides with blue. Place the box with the green side down. Cut out a long green wavy strip and paste over the inside of the green base of the box. Draw and cut flowers, sun and clouds for your garden decoration. For each piece, cut a 5 cm strip of paper. Fold it with a U to hang it. Glue one leg P to the part and the other to the box.

Image
Image

Step 2

Bend the white wire brush or wire into a loop. Wrap the ends around the magnet. Wrap the magnet with black and yellow brushes (or wires). This will be the belly of the bee. Place the second magnet under the bee so that it repels it, i.e. to meet the same poles. Mark the top of the magnet with a pencil. Place the magnet on a piece of tissue paper with the marked side down. Wrap the paper around the magnet and tape. Flip the magnet over and stick the yellow circle on it.

Image
Image

Step 3

Cut a circle out of colored paper. Draw and cut out the petals. Glue to the bottom of the drawer. Press down on the top of the magnet with double-sided adhesive tape. Thread the needle through the threads of the bee's belly. Tie a string so that the bee hangs from it.

Image
Image

Step 4

Pierce the top of the box and thread. Its length should be such that the bee with a magnet hangs over the flower itself. Cut a piece of wire to hold the thread. Take out the needle. Wrap the thread around the wire and tie.

Recommended: