Do you like circus? Is your child impressed for a long time after attending circus performances? Put on a little show at home by creating a juggler clown. He juggles with multi-colored balls, in the roll of which are multi-colored bulbs. When you turn the paperclip by touching the clip on the switch, each of the three lights in turn closes and lights up.
Necessary
- - a box of noodles
- - white and black paper
- - thin cardboard
- - three bulbs of 1.5 V
- - three cartridges for them
- - wires
- - 1.5 V battery in holder
- - paper clip
- - four paper clips
- - felt-tip pen
- - Scotch
- - paints
Instructions
Step 1
First, paint one light bulb with a red marker and one with green.
Step 2
Cover the front of the box with black paper. Draw a clown on white paper and color it. When dry, cut and paste onto black paper.
Step 3
Cut a piece of cardboard to fit into the box. In the black wall, poke holes for the bulbs depicting juggler balls. Mark the cardboard through these holes.
Step 4
Take out the cardboard and tape the cartridges along the marks. Attach a separate wire to each terminal of the lampholders. Gather the wires together from one side of each socket and twist the stripped ends tightly. And glue the other three wires separately with tape at the bottom of the box.
Step 5
Slide the cartridge box into the box. If the cartridges do not fit under the holes, re-glue them. Then screw the bulbs into the sockets through the holes in the front wall.
Step 6
Switch mounting. Poke one paper clip through the square piece of paper. Place a paper clip on it. Add three more clamps so that the other end of the paperclip can touch each one.
Step 7
Cut a hole from one side of the box at the bottom. Route three separate wires through it and connect each of them to the legs of one of the three free clamps.
Step 8
Inside the box, attach a strand of three wires to one end of the battery holder. Wrap the connection with electrical tape so that they do not come apart.
Step 9
Pass the wire from the battery holder through the hole in the box. Wrap the end of the wire around the legs of the clip with a paper clip on the switch.
Step 10
Cover all connections with duct tape, and then tape the switch to the side of the box. Tape the top and bottom of the battery box with tape.
